Mechanical APDL · 2024 R1
CYCOPT
Signature
CYCOPT, OPTION, Value1, Value2, Value3, Value4, Value5, Value6, Value7Summary
PREP7 command that controls analysis options and execution (OPTION, BCMULT, Value1, Reuse array parameter names).
Arguments
| Name | Description |
|---|---|
| OPTION | OPTION parameter for the PREP7 command. |
| BCMULT | BCMULT parameter for the PREP7 command. |
| Value1 | Value1 parameter for the PREP7 command. |
| Reuse array parameter names | Reuse array parameter names parameter for the PREP7 command. |
| COMBINE | COMBINE parameter for the PREP7 command. |
| Value1 | Value1 parameter for the PREP7 command. |
| Enable combining of harmonic index solutions | Enable combining of harmonic index solutions parameter for the PREP7 command. |
| DEFAULT | DEFAULT parameter for the PREP7 command. |
| DOF | DOF parameter for the PREP7 command. |
| Value1 | Value1 parameter for the PREP7 command. |
| FACETOL | FACETOL parameter for the PREP7 command. |
| Value1 | Value1 parameter for the PREP7 command. |
| HINDEX | HINDEX parameter for the PREP7 command. |
| EVEN / ODD | EVEN / ODD parameter for the PREP7 command. |
| ALL | ALL parameter for the PREP7 command. |
| Value1, Value2, Value3 | Value1, Value2, Value3 parameter for the PREP7 command. |
| Value4 | Value4 parameter for the PREP7 command. |
| Value5 | Value5 parameter for the PREP7 command. |
| Improper selection of the harmonic index range may produce in- | Improper selection of the harmonic index range may produce in- parameter for the PREP7 command. |
| LDSECT | LDSECT parameter for the PREP7 command. |
| Value1 | Value1 parameter for the PREP7 command. |
| MOVE | MOVE parameter for the PREP7 command. |
| Value1 | Value1 parameter for the PREP7 command. |
| nodes | nodes parameter for the PREP7 command. |
| nodes | nodes parameter for the PREP7 command. |
| MSUP | MSUP parameter for the PREP7 command. |
| Value1 | Value1 parameter for the PREP7 command. |
| STATUS | STATUS parameter for the PREP7 command. |
| TOLER | TOLER parameter for the PREP7 command. |
| Value1 | Value1 parameter for the PREP7 command. |
| Greater than 0 | Greater than 0 parameter for the PREP7 command. |
| edge component node pairing | edge component node pairing parameter for the PREP7 command. |
| Less than 0 | Less than 0 parameter for the PREP7 command. |
| Value2 | Value2 parameter for the PREP7 command. |
| USRROT | USRROT parameter for the PREP7 command. |
| Value1 | Value1 parameter for the PREP7 command. |
| LOW | LOW parameter for the PREP7 command. |
| HIGH | HIGH parameter for the PREP7 command. |
Manual grouping
- PREP7 : Special Purpose
- SOLUTION : Dynamic Options
This page summarizes syntax and usage in plain language. It does not replace official Ansys documentation. See the full command entry in Ansys Help (Ansys license required).